18F46K42-I/P MIKRO İŞLEMCİ - DIP40 PAKET
PIC18(L)FxxK42 MCUs integrate a rich set of core independent peripherals, intelligent analog peripherals and large Flash/RAM/EEPROM memories. These 28-, 40- and 48-pin devices also offer a host of low power features, performance improvements and design flexibility options that easily and rapidly enable the complex set of functions required by many of today's embedded control applications.
- Interrupt Vector Table
- Programmable single or dual priority
- Two level hardware context saving
- Eliminates need for CPU involvement in data transfers
- Access to all memory spaces and peripherals
- Flexible source and destination message sizes
- Programmable DMA priority
- Memory Access Partition (MAP) - Customize flash partitioning with bootloader write protection
- Device Information Area (DIA) - Dedicated memory area for data storage of temp sensor factory calibration value, factory ID and FVR values for ADC and COMP
- WDT: 500nA @ 1.8V typical
- SLEEP mode: 50nA @ 1.8V typical
- DOZE mode allows CPU to run at a lower clock speed than peripherals
- IDLE and SLEEP modes selectively shut down peripherals and/or core for power reduction
- Averaging, filter calculations, oversampling and threshold comparison (ADCC)
- Automates touch sampling and reduces software size and CPU usage when touch or proximity sensing is required (ADCC)
- 5-bit resolution, rail-to-rail (DAC)
- Unbuffered I/O pin output
- Comparator hysteresis enable
- Invert output polarity
- Fixed Voltage Reference (FVR) module - 1.024V, 2.048V and 4.096V output levels
- Senses high voltage AC signal (ZCD)
- Generates interrupts on zero cross (ZCD)
- DMA compatible
- Asynchronous UART, RS-232, RS-485 compatible
- Programmable 1, 1.5, 2 stop bits
- Configurable length bytes
- Arbitrary length data packets
- Separate transmit and receive buffers with 2-byte FIFO and DMA capabilities
- SMBus, PMBUSTM compatible
- In-Circuit Debug Integrated On-Chip
- In-Circuit Serial Programing (ICSP) via Two Pins